Note: It's important to try the stock settings, especially the PIDs and filters. They have been carefully selected to meet the challenge of optimizing whoop flight. Deviating from the suggested settings can cause unexpected flight behavior or fly-aways.
Based on Blackbox log analysis the tune was greatly improved over the V2! Some settings require the latest firmware features--so we've decided to ship the board with a pre-release of Betaflight 3.4 and settings that performed incredibly well indoors and outdoors with a variety of frames, motors, and props.
Size: 26mm x 26mm, fully compatible with the Inductrix quad frame and mounting pattern
Firmware version: Betaflight ALIENWHOOPF4 3.4.0
Power Cable: 55mm, with JST-PH 2.0 connector, AKA PowerWhoop connector
With 8M flashdata chip for Blackbox
This board supports most serial external receivers via UART3. Officially supporting FrSky XM and XM+ (SBUS), LemonRX DSM2 and DSMX (SBUS), and FlySky FS-A8S (iBUS) satellites.
Newest V2.1 board has integrated the UART inverter for SBUS protocol. So just connect to your Frsky/Futaba receiver normally.
Join Alienwhoop Team on Discord to hang out and pick up tips from other pilots as you build and configure your AlienWhoop. Building alone can be very frustrating and confusing so do yourself a favor and join the community.
1 * Alienwhoop F4 brushed flight controller V2
4 * M1.2x4mm screws (Fit for stock Inductrix frame)
4 * M1.4x5mm screws (Fit for Beta75 etc 75mm frame)